CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
Problem after ICD software/firmware upgrade.....

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
Guest
Problem after ICD software/firmware upgrade.....
PostPosted: Thu May 24, 2007 3:49 pm     Reply with quote
Hi,

I just "upgraded" to version 2.77 of the ICD software, and version 1.37 of the ICD-U40 firmware. After the upgrade, everything seems to work fine (Test ICD, Test Target, etc.), but my known-good target board no longer runs known-good software.......

Is there some setting I need to change? I tried both 'normal' and 'fast' programming modes......

PIC is the 16F628.

Thanks,

Noel
Guest
PostPosted: Thu May 24, 2007 3:51 pm     Reply with quote
Hi,

To be clear, when I click Run Program, or disconnect the ICD from my board my program does not execute. I know this because none of the diagnostic LEDs flash as they should during normal startup of my code.....

Noel
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group