CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
ICD_U40 Prog LF

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
Storic



Joined: 03 Dec 2005
Posts: 182
Location: Australia SA

View user's profile Send private message Send e-mail

ICD_U40 Prog LF
PostPosted: Mon Mar 06, 2006 3:02 pm     Reply with quote
with the 18LF series micro (Low voltage 3.3v micro) I am not able to program the 18LF8621. is there a method in programming the LF micros or do we need to use the MPLAB ICD2 unit. Confused

the ICD2 connect and programs OK however I could not load the hex file into MPLAB to program (extension not recognised)? Sad

Any ideas

Andrew
_________________
What has been learnt if you make the same mistake? Wink
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Mon Mar 06, 2006 4:23 pm     Reply with quote
Quote:
However I could not load the hex file into MPLAB to program (extension not recognised)?


See this thread:
http://www.ccsinfo.com/forum/viewtopic.php?t=26043
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group