CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com

ICD-U40: 3,3V Target-> target not detected; 3,6V Tagret-&

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
PICbastler
Guest







ICD-U40: 3,3V Target-> target not detected; 3,6V Tagret-&
PostPosted: Tue Sep 20, 2005 4:09 am     Reply with quote

I use a PIC18LF6620 with 16MHz Resonator.

When I drive my circuit with Vdd>3,6V it runs propper with ICD-U40.

But when I reduce Vdd to 3,3V the ICD-U40 could not detect the
target chip Sad .

The Pin2 on ICD-Interface is connected to 3,3V and the MCLR is
pulled up to 3,3V with 10k.

What can I do to use the ICD-U40 with my 3,3V target Question ?

#include <18F6620.h>
#device ICD=TRUE
#device adc=8
#FUSES NOWDT //No Watch Dog Timer
#FUSES HS //High speed Osc (> 4mhz)
#FUSES DEBUG //Debug mode for use with ICD
#use delay(clock=16000000)
kender



Joined: 09 Aug 2004
Posts: 768
Location: Silicon Valley

View user's profile Send private message Send e-mail Visit poster's website Yahoo Messenger

PostPosted: Sat Oct 22, 2005 4:25 pm     Reply with quote

16MHz could be too high of a frequency to run at 3.3V. Check with a chart in the figure 26-4 on the p.309 of the datasheet.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group