CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
Hardware SPI with software I2C, any problems?

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Guest
Guest
Hardware SPI with software I2C, any problems?
PostPosted: Mon Jul 26, 2004 11:16 am     Reply with quote
Hi,

I have a new project using a 16F252 or 18F252 (not sure yet) I am going to interface with a MCP3208 A/D via hardware SPI and then a FRAM chip via software I2C, does anyone know of any problems with software I2C compiler v3.148. or should it be OK?

Thx
Charlie U



Joined: 09 Sep 2003
Posts: 183
Location: Somewhere under water in the Great Lakes

View user's profile Send private message

PostPosted: Mon Jul 26, 2004 2:46 pm     Reply with quote
I ran the same set up with a 16F877 and had no problems. In fact, there were 2 soft I2C interfaces since I had 2 different I2C devices with the same address.
guest
Guest
Thanks
PostPosted: Mon Jul 26, 2004 3:39 pm     Reply with quote
THanks I have the confidence to start the project now Very Happy
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group