CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
18F452 Enhanced PWM mode setup in CCS

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
gunking88



Joined: 18 Jun 2004
Posts: 11
Location: WV

View user's profile Send private message Send e-mail

18F452 Enhanced PWM mode setup in CCS
PostPosted: Fri Jun 18, 2004 1:49 pm     Reply with quote
hi, all, I have a question about :18F452 Enhanced PWM mode setup in CCS
is there any built-in function to setup Enhanced PWM mode with two PWM signal output for push pull application? thanks a lot
ttelmah
Guest
Re: 18F452 Enhanced PWM mode setup in CCS
PostPosted: Sat Jun 19, 2004 2:33 am     Reply with quote
gunking88 wrote:
hi, all, I have a question about :18F452 Enhanced PWM mode setup in CCS
is there any built-in function to setup Enhanced PWM mode with two PWM signal output for push pull application? thanks a lot

Er.
The 18F452, only has the CCP module, not the ECCP module. Hence no support for push-pull operation. Check the chip's data sheet.

Best Wishes
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group