CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com

Problem w/ older MACHX

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
sseidman



Joined: 14 Mar 2005
Posts: 159

View user's profile Send private message

Problem w/ older MACHX
PostPosted: Thu Jul 16, 2015 9:24 am     Reply with quote

I'm trying to use an older version MachX with the newest firmware (Hardware rev 2, firmware 1.26) with ccsload software version 5.019 on a windows 7 machine. I'm using the ZIF socket

Fails miserably, with the target device ID reading zeros.

The Messages tell me:
Quote:

11:20:32 Assigning chip: PIC12F617
11:20:32 Loaded: PIC12F617
11:20:32 Write FILE -> CHIP
11:20:32 Setting Vpp=0

But I get a Programming Failed message.

Using the same hardware on my laptop, running software version 4.045, everything works!!


Any fixes? I assume it's a bug, as the old version works. I'm not set up right now to see if the ICD works.
newguy



Joined: 24 Jun 2004
Posts: 1899

View user's profile Send private message

PostPosted: Thu Jul 16, 2015 10:00 am     Reply with quote

Did you let CCS know yet? I've run into similar problems with the load-n-go where new FW revs completely break an old HW rev unit, and certain ccsload revs do the same.

To be honest, you're probably not going to get any resolution. It's been almost 3 years since I let them know about the load-n-go issue I first discovered in front of customers (! - last time I blindly updated my load-n-go) and I still have no fix. I believe my unit is HW rev 2 and they're currently selling HW rev 4 units. They're just not actively supporting the older stuff anymore.
sseidman



Joined: 14 Mar 2005
Posts: 159

View user's profile Send private message

PostPosted: Thu Jul 16, 2015 10:16 am     Reply with quote

I just sent them off a copy of the post. I figured I'd try to figure it out first.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group