CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug Reports on this forum. Send them to support@ccsinfo.com

ICD-U40 : Target not recognized

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
Christophe



Joined: 10 May 2005
Posts: 323
Location: Belgium

View user's profile Send private message

ICD-U40 : Target not recognized
PostPosted: Mon Feb 01, 2010 9:21 am     Reply with quote

Hello,

I'm using CCSLOAD 4.022 with the ICD-U40.

I always get the following error:

"Target not recognized. Device ID = 3FFF."

However, my hardware connections are OK, because it used to work earlier.

Is my programmer dead?
What can I do?

best regards;
dcclark



Joined: 28 Jan 2009
Posts: 5

View user's profile Send private message

ICD-U40 : Target not recognized
PostPosted: Mon Mar 01, 2010 1:49 pm     Reply with quote

Make sure the RJ11 cable connector is seated firmly in the ICD. I have had this problem at least twice.
Christophe



Joined: 10 May 2005
Posts: 323
Location: Belgium

View user's profile Send private message

PostPosted: Tue Mar 02, 2010 1:46 am     Reply with quote

Hey,

thanks for replying; I found all my programmers to be dead. I bought a new one and everything was fine.

regards
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group