CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug Reports on this forum. Send them to support@ccsinfo.com

ICD-U40 can't connect with PC

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
stefan_d6



Joined: 17 Aug 2006
Posts: 6
Location: Varna, Bulgaria

View user's profile Send private message

ICD-U40 can't connect with PC
PostPosted: Sat Dec 16, 2006 5:35 am     Reply with quote

I've got a new ICD-U40.
I installed its drivers (setup_usbdrivers.exe) and the PC recognizes it with no problems - CCS ICD-U40 in Device Menager. Then I installed ICD.exe (setup_icd.exe). My PCW is v.3.235.
But when I try to run ICD.exe a message occurs:

Access violation at address 01225287 in module "ftd2xx.dll". Write of address 01270000

and after confirming the window Start Connection appears but only with two possible choices - COM1 and COM2. Neither of them works.

Where is the problem
stefan_d6



Joined: 17 Aug 2006
Posts: 6
Location: Varna, Bulgaria

View user's profile Send private message

PostPosted: Sat Dec 16, 2006 6:31 am     Reply with quote

I solved the problem.
It seems the new driver from www.ccsinfo.com is not for my ICD-U40. I used the old one -DriverVer=10/15/2004,1.06.20
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group