CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
USB Prototyping board terminal block

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
JohnMajor
Guest
USB Prototyping board terminal block
PostPosted: Thu Feb 23, 2006 3:19 pm     Reply with quote
Spent all last night trying to get my code working on the USB Prototyping board; external eeprom. Focused on possible errors in the code, just assumed that the pinout(page 45) in the 'Development Kit for the USB Exercise Book' was correct. Well I figured out this morning that it is not even close. Asked for correct pinout from ccs but no reply. Does anyone have the correct pinout or know if the one in the schematic on page 46 correct?
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group