CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Branching to the end of a loop
Goto page Previous  1, 2
 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
temtronic



Joined: 01 Jul 2010
Posts: 9632
Location: Greensville,Ontario

View user's profile Send private message

PostPosted: Fri May 29, 2020 5:33 am     Reply with quote
comment.
it might be a good idea to define the motor control pins with names. Replacing PIN_B5 with 'portmotorup' or some other easy to KNOW what it's for, might help. It sure makes changin pin assignements easy when someone flips b6 for b8..cause they look the same without bifocals on......

jay
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Goto page Previous  1, 2
Page 2 of 2

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group