What you do is solder pins to each of the gold U shaped areas that are the 'pinouts'.
Be sure to measure the spacing or check the datasheet as they can be either metric or std (.1") !
Usually the seller supplies 2 'strips' of pins to allow you to plug the module into a socket or breadboard.
The data sheet for the module gives the PCB pad layout required. Remember you must _not_ have a ground plane or power plane under the antenna area. This needs to be sticking out beyond the tracking or have a large void.
Joined: 25 Apr 2011 Posts: 247
Posted: Tue Jan 09, 2018 2:57 pm
Thanks to all for your help. Hope that others will find this query useful as well.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum