CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
termination resistor calculation in CAN bus

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
prabu



Joined: 29 Jan 2015
Posts: 8
Location: india chennai

View user's profile Send private message

termination resistor calculation in CAN bus
PostPosted: Thu Jan 29, 2015 5:49 am     Reply with quote
How to calculate termination resistor in CAN
newguy



Joined: 24 Jun 2004
Posts: 1903

View user's profile Send private message

PostPosted: Thu Jan 29, 2015 7:27 am     Reply with quote
There's no calculation. It's 120 ohms for the two endpoints. If you have any mid-span nodes, you can either leave them terminationless or set them high. I typically set mine as 2.6k.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group