Just tried to hook up the ICD-U40 up to a PIC18F26J40. Opened up CCSLOAD and found my part in the list and it failed to detect my part. I then disconnected the part and ran diags. VPP sits at 4V. I select a different part and VPP is fine at 10V.
The VCC of target part is 3.3V. I loaded up an older version of ICD programmer and found I have 1.36 firmware revision w/ #97 hardware revision (not sure how to find this info. CCSLOAD - What happened to the older programming software?).
Any help on getting this part to program with my ICD-U40? _________________ -Matt
Joined: 11 Nov 2003 Posts: 118
Posted: Fri Apr 23, 2010 4:13 pm
Just got a new ICD-U64 and all works good. For some reason the whole 3V-5V and 3V only thing is just a little confusing. Have no time to wait for a hardware Rev update. Unless it can be done myself? _________________ -Matt
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum