CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
a SPI DAC chip and using ICD3

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
jaethelegend
Guest
a SPI DAC chip and using ICD3
PostPosted: Tue Jun 09, 2009 6:58 pm     Reply with quote
Hi
I am trying to use serial DAC with my PIC. I am using ICD3 to power it and debug it.
When I try to do that, however, an error occurs stating that the device code does not match.
If I program(using debugging mode), after taking out the DAC IC, the programming works but if I plug the DAC back in, and try to run, I get an error message.
Anyone have the same problem?
andyfraser



Joined: 04 May 2004
Posts: 47
Location: UK

View user's profile Send private message

a SPI DAC chip and using ICD3
PostPosted: Wed Jun 10, 2009 6:38 am     Reply with quote
Hi,

It sounds like you have PGC or PGD connected to the DAC which is getting in the way of the ICD 'speaking' to the processor.

Andy
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group