CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug Reports on this forum. Send them to support@ccsinfo.com

Lcd include file allowing pins from more than one port

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Rod Phillips
Guest







Lcd include file allowing pins from more than one port
PostPosted: Tue Dec 31, 2002 4:34 pm     Reply with quote

Hello to All,

I'm using an Olimex PIC-MT development board and it's included LCD display uses port_a for control and port_c for data. My question is - are there any include files that allow selecting invidiual pin functions rather than an entire port to drive a display. Thanks in advance for any information.

Rod
___________________________
This message was ported from CCS's old forum
Original Post ID: 10366
PCM programmer



Joined: 06 Sep 2003
Posts: 20142

View user's profile Send private message

Re: Lcd include file allowing pins from more than one port
PostPosted: Tue Dec 31, 2002 4:43 pm     Reply with quote

:=Hello to All,
:=
:=I'm using an Olimex PIC-MT development board and it's included LCD display uses port_a for control and port_c for data. My question is - are there any include files that allow selecting invidiual pin functions rather than an entire port to drive a display. Thanks in advance for any information.
:=
----------------------------------------------------------

Mr. Fick has got this on his page. He uses Port A for the
data, and two bits on port B for the control lines.
<a href="http://www.VermontFicks.org/pic.htm" TARGET="_blank">http://www.VermontFicks.org/pic.htm</a>
Scroll down to where it says "LCD routines".
___________________________
This message was ported from CCS's old forum
Original Post ID: 10368
Rod Phillips
Guest







Re: Lcd include file allowing pins from more than one port
PostPosted: Tue Dec 31, 2002 5:39 pm     Reply with quote

:=:=Hello to All,
:=:=
:=:=I'm using an Olimex PIC-MT development board and it's included LCD display uses port_a for control and port_c for data. My question is - are there any include files that allow selecting invidiual pin functions rather than an entire port to drive a display. Thanks in advance for any information.
:=:=
:=----------------------------------------------------------
:=
:=Mr. Fick has got this on his page. He uses Port A for the
:=data, and two bits on port B for the control lines.
:= <a href="http://www.VermontFicks.org/pic.htm" TARGET="_blank"> <a href="http://www.VermontFicks.org/pic.htm" TARGET="_blank">http://www.VermontFicks.org/pic.htm</a></a>
:=Scroll down to where it says "LCD routines".

Thanks for the information PCM and thanks to Mr. Fick. I'm still on shaky ground and this sort of information sharing is much appreciated.

Rod
___________________________
This message was ported from CCS's old forum
Original Post ID: 10375
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group