CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
Programming 3.3V PICs IN-CIRCUIT?

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
davefromnj



Joined: 03 May 2007
Posts: 42

View user's profile Send private message

Programming 3.3V PICs IN-CIRCUIT?
PostPosted: Wed Apr 09, 2008 8:50 am     Reply with quote
Hello All,

Is there a way to program the 3.3V 18F65JXX PICs with just a programmer, and keeping the target board shut off?

This can be done with 5V MCUs and the ICD2 as long as the ICD2 has the Wall-Wart plugged in to provide power, but the option to program 3.3V PICS gets grayed out when you use an 18F65JXX series part.

I am not sure if this message is appropriate for this forum, if not I appologize.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group