CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
Problem Programming PIC18F87J10

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
Barclay



Joined: 12 Mar 2007
Posts: 1

View user's profile Send private message

Problem Programming PIC18F87J10
PostPosted: Thu Mar 15, 2007 10:41 am     Reply with quote
I have a problem trying to program the 18f87J10 (3.3V device) using ICD-U40 (upgraded to 2.14 #100 Firmware) and the latest ICD executable.

The Vcc pin on the ICD is conneted to target board's 3.3V supply.

ICD detects the target when "Test Target" is selected and can read out the empty PIC's memory, but an error message appears after selecting the HEX file I am trying to load.

Has anyone successfully programmed this PIC with CCS ICD?

CCS assured me that the 3.3V PIC18F87J10 was supported, but I can't seem to get it working.

If anyone has any suggestions they would be much appreciated.

Thanks.
Guest
PostPosted: Fri Nov 07, 2008 7:23 am     Reply with quote
i'm also stuck in same issue....
plz anyone help for this.....
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group