CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com

How can I make PIC to auto-run once I apply voltage?

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
sonicdeejay



Joined: 20 Dec 2005
Posts: 112

View user's profile Send private message

How can I make PIC to auto-run once I apply voltage?
PostPosted: Tue Dec 20, 2005 2:45 am     Reply with quote

How can I make PIC to auto-run once I apply voltage?

Currently, I can only make it run by debugging from ICD2.0... Smile
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Tue Dec 20, 2005 10:44 am     Reply with quote

Quote:
How can I make PIC to auto-run once I apply voltage?

This thread has instructions on how to do it:
http://www.ccsinfo.com/forum/viewtopic.php?t=21415
sonicdeejay



Joined: 20 Dec 2005
Posts: 112

View user's profile Send private message

PostPosted: Wed Dec 21, 2005 5:40 pm     Reply with quote

Thx alot for the support.. Very Happy
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group