CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
ICD0083: Target not in debug mode, unable to perform operati

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
tbsnake



Joined: 17 Jun 2004
Posts: 3

View user's profile Send private message

ICD0083: Target not in debug mode, unable to perform operati
PostPosted: Thu Jun 17, 2004 8:10 pm     Reply with quote
I cant seem to debug with pic16f688, I always get the error:
ICD0083: Target not in debug mode, unable to perform operation
Yet the #device ICD=TRUE command is there, and the NOP at location 0. Is there a setting I am missing somewhere? Smile
Haplo



Joined: 06 Sep 2003
Posts: 659
Location: Sydney, Australia

View user's profile Send private message

PostPosted: Thu Jun 17, 2004 9:19 pm     Reply with quote
I had this problem once. the cause was a bad power supply connection, which reset the pic after ICD had programmed it. You might be experiencing the same thing.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group