I'm working on this project below, I'm curious though if I need to include the command #fuse MCLR for this project or not. The project has a reset button that takes the normally low MCLR pin high to reset the PIC, or is it not necessary to include this fuse?
Joined: 06 Sep 2003 Posts: 21414
Posted: Tue Mar 27, 2007 12:05 am
I'm curious though if I need to include the command #fuse MCLR for this project or not.
Look at the list of available fuse settings at the start of the
Also look in the 16F876A data sheet, in the section called
"Special Features of the CPU". Look at the diagram of the
This will answer your question.
Joined: 27 Dec 2006 Posts: 55 Location: Western New York - USA
Posted: Wed Mar 28, 2007 2:45 pm
In your hardware may wish to add a resistor of 330 ohm to the osc2 line,
this reduces crystal over drive.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum