CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com

PGM Pin

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
SeeCwriter



Joined: 18 Nov 2013
Posts: 159

View user's profile Send private message

PGM Pin
PostPosted: Thu Feb 26, 2015 10:56 am     Reply with quote

The 18F87J60 does not have an identified PGM pin. What pin should I connect the ICD pin 6 (DIAG) to on the CPU?
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Fri Feb 27, 2015 12:24 am     Reply with quote

http://www.ccsinfo.com/faq.php?page=connect_icd

Quote:
Pin B3 is an optional pin connected to the ICD-S/U that allows use of the
monitor feature while debugging. If pin B3 is used in the target circuit or
is not connected to the ICD-S/U, the target can still be programmed and
debugged, except without use of the monitor feature. When debugging,
disabling the userstream feature will ignore the connection between pin 1
on the ICD-S/U and pin 6 on the target device. Older versions of the
debugger software require that if the monitor is not used, the pin
connection on the ICD connector needs to be pulled high at all times.
While pin B3 is recommended for the monitor feature, any pin on a PICĀ®
MCU or PICĀ® DSC can support this feature.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group