CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com

Mach x hadware (Rev5.0)PCB problem

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
mohammad3d



Joined: 28 Mar 2009
Posts: 17

View user's profile Send private message Send e-mail

Mach x hadware (Rev5.0)PCB problem
PostPosted: Fri May 07, 2010 3:56 am     Reply with quote

Hi every one,

I buy an Mach x programmer(Rev 5.0) and when try to install and connect to my
computer,get several error like this,
driver install compelet but when connect programmer to computer USB port I get an error message "Unknown USB device".
I try to fix this error by work on driver installing but nothing change and
harware error still remain.
finaly I think USB converter IC (FT232Bl)maybe damage and replace it with one new chipset ,but this error remain.
At last I replace FT232 Ic from mach X PCB and draw FT232 IC connection
in Circuit and compare with FT232 datasheet.
This is amazing,I find some wrong connection and some wrong component
assignment in Mach X PCB and try to fix this problems.
After fixing this problems and update Mach X firmware ,my programmer
work fine without any problem.I test it in ZIF programing ,In circuit programing and in debug mode,and it work very fine.
Detail of modification is:
1-FT232 chipset configure in "USB Bus Powered" mode and in this mode
pin 14(POWERCTL) must connect to GND Not VCC.In my hardware PCB
it connect to VCC.
2-pin 30(AVCC) must connect to GND via an 0.1Uf capacitor but in My PCB
it connect to pin 3(VCC).
3-Pin 6(3v3OUT)must connect to GND via an 33nf capacitor but in my
hardware it connect to pin 7(USB DP) via 1.5K resistor.I fix this by cutting
PCB path.
4-pin 5(RSTOUT#)must connect to to pin 7(USB DP) via 1.5K resistor but
in my hardware PCB it No connect.

after fix this connection and modification my programmer work fine.
If you interest my modification I can Send you my modified PCB image. Very Happy

best regards,
Mohammad kouchekzadeh.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group