CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com

No respose from ICD-U40

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
Bjoern
Guest







No respose from ICD-U40
PostPosted: Thu May 20, 2004 7:53 am     Reply with quote

Hi,

Running the ICD-U40 with the PCWH compiler under windows ME, every
time my code was running and I click on the stop button in the debug
window, I get a "No response from ICD" error. After this the interface
hangs, with blinking green LED. If I now click the reset button I get I
few more error messages, before the ICD works normaly.

I've programmed the 1.25 firmware to the ICD-U40 and working with
PCWH V 3.190.

I've also tried to run the compiler and the ICD-U40 on my laptop with windows XP, there I get buffer overflow messages after clicking stop.

Is there someone who hab the same problem and can someone give me
an solution ?
Bjoern
Guest







PostPosted: Thu Jun 17, 2004 1:59 am     Reply with quote

Hi,

again it's me. I've solved the problem with help from
CCS support.

The cable between ICD-U40 interface and my controller
was to long. Keep this connection as short as possible
10 inch max. helped.
Razz
cagacug



Joined: 14 Apr 2004
Posts: 5

View user's profile Send private message

PostPosted: Wed Jun 23, 2004 2:33 am     Reply with quote

Hi,

I have the same problem with ICD-S40. Sadly I could not have any solution, hope someone has a idea.
Guest








If the debugger does not stop
PostPosted: Fri Jun 25, 2004 6:21 am     Reply with quote

Hi,

I've another problem solved. If you use the ICD_U interface
don't set the low voltage programming pin to output set it
to input instead.

This sometimes helps if your debugger hangs, when you try to stop
the program from running.

Also don't use the sleep mode, if the controller is in sleep mode,
the debuger can't stop it anymore.

Bye, Bjoern.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group